2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 473Get this manual

2006-2008 Yamaha Snowmobiles Apex/Attak Factory Service Manual, Page 473

CABLE ROUTING Route the fuel tank breather hose along the steering gateClamp the compression spring section of the fuel tank
hose Clamp the fuel tank breather hoseBind the two tube leads on the steering column side at one point by wrapping the tape
(black) to turnsThe end section of tape should not be peeledMain switch Flange nut Hexagon bolt Route the lead by the inside
of the wire harness and sub-wire lead (ignition coil lead)Clamp the wire harness, cylinder identification sensor (together
with the connector cover) and sub-lead wire (ignition coil lead)Cylinder identification sensor Clamp the wire harness and