2007-2008 Yamaha Phazer Venture-Lite 500 Factory Service Manual, Page 24Get this manual

2007-2008 Yamaha Phazer Venture-Lite 500 Factory Service Manual, Page 24

COOLING SYSTEMVALVE CLEARANCE ADJUSTMENT INSP ADJ Air bleeding steps: Remove the cap on the radiator outlet pipe While slowly
and excessive V-belt wear could occur, or the machine could unexpectedly move forward if the clutch engages Operate the engine
only in well-ventilated area Remove the coolant filler cap and bleed the cooling system again, as described aboveNo air bubbles
OK Pour coolant into the coolant reservoir until the coolant level reaches the "COLD LEVEL" mark b VALVE CLEARANCE ADJUSTMENT
NOTE: Valve clearance adjustment should be made on cold engine, at room temperature When the valve clearance is to be measured
or adjusted, the piston must be at the top dead center (TDC) on the compression stroke1Drain: Engine oil Refer to "ENGINE