2007-2008 Yamaha Phazer Venture-Lite 500 Factory Service Manual, Page 239Get this manual

2007-2008 Yamaha Phazer Venture-Lite 500 Factory Service Manual, Page 239

CRANKCASE Tighten the connecting rod boltsConnecting rod bolt: 1st: 20 Nm (2.0 kg, 14 ft lb) Final: Specified angle 120130
specified angle (120130) WARNING When the bolt is tightened more than the specified angle, do not loosen the bolt and then
retighten itReplace the bolt with new one and perform the procedure again CAUTION: Do not use torque wrench to tighten the
bolt to the specified angle Tighten the bolt until it is at the specified angles Remove the connecting rod and big end bearings