2007 Yamaha Apex Factory Service Manual, Page 89Get this manual

2007 Yamaha Apex Factory Service Manual, Page 89

REAR SUSPENSION Control rod 1Adjust: Control rod stroke a INSP ADJ CAUTION: Make sure the adjusting bolt ends are set at
rods beyond the maximum range indicated on the rods with red paint While holding the adjusting bolt securely, tighten the
locknut Locknut: 25 Nm (2.5 mSkg, 18 ftSlb) Rear suspension position (RX10M, RX10MS) 1Adjust: Rear suspension position NOTE:
Select the rear suspension position according to the snow conditions: standard; deep new snowBolt (slide rail suspension):