2007 Yamaha Apex Factory Service Manual, Page 129Get this manual

2007 Yamaha Apex Factory Service Manual, Page 129

DRIVE CHAIN HOUSING INSTALLATION 1During installation, pay attention to the followingA Properly install the rubber seal onto
D 0.2 0.6 mm (0.008 0.024 in) : ESSO beacon 325 grease or Aeroshell grease #7A For the jackshaft and drive chain housing
installation, refer to "SECONDARYSHAFT" 2Install: Lever rod 3Adjust: Lever rod length Adjustment steps: Loosen the locknuts
Turn the lever rod in or out until the specified length is obtainedLever rod length: 27 mm (1.06 in) Tighten the locknuts