1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 146Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 146

VOTEIJ dril'e shuJt splines do no: aif!.n with clutch disc plinesrolute unit ersal join shaft diglttly until dritJe can be
is re le oe durin Lh shi ftin cyc leWhen the lutch plate is out of position the drive unit ca nn ot installedIn order repositionClu
tch Plate Alignm nt Tool (C-91-57795) mu be ed in nd ngine Alignm nlShaft-92 -57797A1)Rea lim1 as follow: lIns ert Eng ine
Ali gnme nt haft with CIUlCh Align ment Tool thru cl utc plate splin with lh lectri shift control connect and pIae in neutral
positi on When the tool is fully thru lutc plat hift the con trol into forward This will hold clutch la te in alignment 2Remove
fll se from bolder in red lead (local over en gine flywhe housing) La pren:nt po sible sh ft cycle without he drive installed3Remov
li gn ment is an in sta ll drive uni tW ORTLeav this fus dri unit is no in all d.to dL onnected whe lh To manually re clutch
pLat eremove [use from holder {located over engine flywheel housing} and lum arel), clutch tou:aTd orward gear {in direction