1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 253Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 253

flat, smooth surface and press diode into pOSItIOn with Tool J-9600-2Make ure that diode is square with end frame and started
as outlined "Di ode Re plac eme nt"precedin g3Assembl heat sink to end frame, carefull followin proper equence of parts on
"BAT" andGRND" termi a1 bolts(Fi gure 12) BL CK INSULATORS FLAT ME TAL WASHERS lO CKWASHERS HAT WASHER FIBER INS ULATOR HEAT
SI NK Fig ure 12 art Sequence SLIP RING END FRAME BEARING NOT E: If grease supply in end fram be aring is exhaust ed, be:uing
should be re place dDo not re lubric at bearing1Support end rame on hollow cyl ind r2Press bearing toward insid of frame
with mandrel th at will just fi inside end fram housingCarefull note assembl of seals so that they can be reassembl ed in
same mann er3 Support insid of frame with ho llow cylinder to preve nt breakage of end frameCA TION: Asse mbl sea ls fl us
with bearing, but avoid excessive press ure, si nce this may di tort and damage seals It is re ommend ed that new eal be