1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 254Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 254

DRIVE END FRAME BEARING REPLACEMENT ' 1- Remove bearing 2Support frame on toward inside of gTease slinger3If bearing is In
1Slide wide collar on pulley end of rotor shaft2Place rotor shaft thm drive end frame bearing and seals3P lace narrow collar,
fan, pulley, wave washer and nut OD rotor shaIt4Place rolor irvise and tighten only enough to permit tightening shaft nut
to 50-60 ftlbs(69-8.3 mkg)5Pla ce stator assembly in end frame and connect leads to attaching studs with nuts6Place end fram
assemblies together, lining up scrihe man-s made on frames before disassemblyInstal thru bolts and tighten evenly8Wipe slip
rings thoroughl with soft dry cloth to remove lubri cant accumul aled whe rings were inserted thm bearings during assembly