1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 572Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 572

4Install water hose to gimbal housing and to bell hous IDg5 Install universal joint bellows to gimbal housing and to bell
gasket to assure good seal and to prevent water leakage NOT E: MerCruis er 60-80-90 have hole, loc ated in bottom o[ gimbal
housing, to [acilitate installing exhaust bellows clamp figure 4Hose Clamp Locations in Bell Housing MODELS l-thru-165, 888
and E-Z SHIFT ! OTERepair procedures [or MerCruiser -thru-16 and 888 are parallel, except where indicatedReIer to preceding
pages [or MerCruiser 60-80-90 REMOVAL 1Remove drive shaft housing assembly according to preceding instructions2Disconne ct
shift cable from inner transom plate and remove cable end guideRemove burrs made by set screws on core wire so that inner
lining of cable will not be damaged when wire is removed3Remove inner wire and cable slide4Loosen cable end insert Jam nut
and back insert out of cab le5On some models, remove clamp whi ch secures shift cable to inner transom plate6Remove hinge
pin lock screws or pins and remove hinge pins with Hinge Pin Puller (C-91-32327 l)or with Slide Hammer Puller (C-91-34569.4.1)