1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 582Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 582

REASSEMBLY (Sealed Bearing) NO TE: Ball bearing is sealed Do not ll em plto clean or lubricate(FigIJrr 7) I Late tylc ball
Gimbal bearing is lubricat through rease filling {located on right id of gimbal housing}if imbal housing does not haue grease
filtinglhen bearing mu be remo cd to lubricate as fo llow]Re move dr iv' unil from bell housing as utli[l r:d in "Removal",
cction 2Twist bearing: and lign with slot in cartridge3Pull bearing from cartridge suitabl tap red fitng nd on lubricant
gun GLI cartri dge baring with (ONL) u.i cksilvcr l lultipur po Lubricarlt9_49588)5Realign bea rin with cartridge slo ts
and ins ta ll beari ng, 1R-movt' dril'(' unil from II ho ing a "R mOlal "2Rc mo e (Figure L) ring Idlh Rin Pliers (C913-AOAI)
NOTE: Use Entrine lignmen haft (C9 14824 fir C-91S7797,43) to align gimbal baring after inslnllation and check engine aiifTltmenl
6Ins tall drive unit utlin ed in "lns tallati, For REPLACING CARTRIDGE ASSEMBL Y CA 'TIO: Gimbal bearing ma be damag during