1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 583Get this manual

1963-1973 Mercruiser all Engines and Drives Service Manual Books 1 and 2, Page 583

3Remove hearing cartridge asse mbly with lools illustrated in Figure 13Two (2) plate_ (.91-29.310) must be usedPosition plates
with tools illustrated in Figure 143In ert Driv er He ad (C91-32325) thru Mandrel (C-91-30366) and in to inside diameter
of bearing assembly 4AJign bearing cartridge assembly with gimbal housing cavityPlaee Plat (C-91.2931O) between top and middle
studs (on beU housing) as pilotDrive hearing cartridge assembly into gimbal housing cavity with lead hammer or mallet5Lubricate
cartridge gimbal bearing with Pistoluber (C-91-37299)using ONLY Quicksilver Multipurpose Lu bricant (C-92-49588) thru grease
fittin gPump 40 full strokes (I oz to adequately lubricate bearing6Install snap ring(Figure (2) NOTE: Use Engine Alignment
Shaft (C9148247 or C91 -S7797 A3) t'o align gimbal bearing after installnt-ion and check engine alignment "Part of Kit (C-9
131229A4 ) (C-91-3232S0) Drill!!r Head_ (e-9 12931 0' 7Install drive unit as utlined inInstallation", Section : Gimbal Housing